1934 Ford Tudor Sedan

Asking 60,000 APPRAISED AT $70,OOO
My 1934 ford tudor that I bought in 1949 IN SO. CALIFORNIA
I put it in storage in 1951 and brought it out in 1998 to do a resto rod build from ground up.
Call for all information, way to much to list here.
It has taken several best of shows around the country, as we moved around the country.

PARTIAL LIST OF PARTS USED ON THIS 1934 BUILT BY GIL LIPPIINCOTT

The body was mine -- no cutting, no rust, no chop, no channel. Body is completely stock. the windshield and cowl vent still work and the door and windows work with the stock regulators.--the only power actuated parts are the safety door pins so suicide doors won't fly open
1 TOTAL COST INVOLVED Stage 3 I had the frame powder coated
2 T.C.I. independent front suspension ( s/s and chrome )
3 Wilwood disc brakes, front and rear ( all polished )
4 T.C.I. rear parallel 4- link suspension s/s
5 T.C.I. front pannard rods and rear anti-roll bar s/s
6 Currie 9" ford differential ( rear end ) with 3.70 gears
7 Rock valley s/s gas tank with s/s fuel punp and plumbed for G.M. t.b.i. and sender
8 All gas lines are from pure choice motorsports and inline filter
9 All brake lines are plumbed in s/s
10 The engine is a crate 1998 chevy lite truck 350 with 4 bolt mains in case I wanted to build the engine and put a blower on it. It also came with T.B.I. so I left it on and had to put all the sensors and the control (computer) on.The T.B.I. wiring harness and controller came from Street and Perforfance
11 Ron Francis wire kit
12 Lokar dip sticks, emergency brake and throttle cable
13 The trans was built by Phoenix transmission products and is a 700 R4 I installed an oil cooler w/fan and thermostat switch for trans heat if it should ever need it
14 Inland Empire driveline - drive shaft
15 Bitchen products firewall for SB CHEVY
16 Vintage Air and heat
17 34 dash w/Dakota digital alum. inserts and instraments, clock and accessories
18 Dakota Digital cruise control
19 I DID IT, tilt steering column with removable steering wheel ( banjo, leather wrapped )
20 Clarion radio mounted in overhead console built by me with a remote disc changer mounted behind the rear seat
21 Julianos 3 point front seat belts, plus rear belts.
22 Interior is covered in Cream leather
23 I have not touched on all the extra work and parts in this car , such as the Gary McLean wire wheels.

A very nice tilt bed trailer goes with it. Also extra parts and
trophy's if you want them. (Less than 200 miles since build)

CALL 928 485 2378 (HOME) 928 322 5046 ( CELL ) ARIZONA Ask for Gil.
SOLD

$60,000
Location Pima, Arizona
Mileage: under 200
Engine: 350 Chevy motor
Body Type: 2 door, hard top
Interior: Off White Leather
Exterior: Dark Green

6786 Ad Views

Related Ads

Contact the advertiser about this 1934 Tudor
Advertisers phone number: --